西卡214金属灌浆料说明西卡214金属灌浆料说明
01/2007 SAFETY DATA SHEET Sika Ltd., China No.96,JunDa Road, Eastern Section, GET w Guangzhou, China, post code: 510530 Sikadur 42HE, Part A Tel: +86 20 82266066
Fax: +86 20 82266022
Page: 1 / 2
PRODUCT DESCRIPTION: Solvent free, flowable, 3-...
西卡214金属灌浆料说明
01/2007 SAFETY DATA SHEET Sika Ltd., China No.96,JunDa Road, Eastern Section, GET w Guangzhou, China, post code: 510530 Sikadur 42HE, Part A Tel: +86 20 82266066
Fax: +86 20 82266022
Page: 1 / 2
PRODUCT DESCRIPTION: Solvent free, flowable, 3-companent synthetic mortar based on Epoxy resin .
PRIMARY HAZARD: SECONDARY HAZARD:
1.1 Chemical Character: modified epoxy resin on bisphenol A.
1.2 Form: liquid.
1.3 Color: colorless
1.4 Odor: slight
2 PHYSICAL AND SAFETY DATA (Not technical specifications. Unless specified tested at 20?. All temps quoted in ?)
2.1 Changes in Physical state: 332.2 Density (20?) Kg/L: 1.13 g/ml Bulk density (kg/m ): kg / m
2.3 Vapor pressure:
2.4 Viscosity(23?): 550?60 mPa.s,
2.5 Water solubility: insoluble
2.6 PH Value: 6
2.7 Flash point:
2.8 Ignition Temp.:
2.9 Explosion limits: N/A
2.10 Thermal decomp.: :>170?
2.11 Hazardous decomposition products:
2.12 Hazardous reaction:
2.13 Further information:
3 TRANSPORT
IMDG: UN No.: ICAO/IATA: Tremcard No.:
GGVE/GGVS: RID/ADR: ADNR:
Other information:
4. REGULATIONS
5 PROTECTIVE MEASURES, STORAGE AND HANDLING
5.1 Technical protective measures:
DO NOT TRANSFER INTO UNLABELED CONTAINERS.
5.2 Personal: Respiratory protection: Not applicable
Eye protection: Tightly fitting protecting goggles.
Hand protection: Gloves, e.g. rubber.
Other:
5.3 Industrial hygiene: EXPERTS ALWAYS WEAR THE RIGHT PROTECTIVE CLOTHING.
Observe good house keeping and general hygiene guidelines.
5.4 Protection against fire and explosion: N / A
5.5 Disposal: Product: must be disposed of in a special waste disposal unit in accordance with the corresponding regulation
Packaging: completely emptied packagings can be given for recycling. Packaging that cannot be cleaned should
be disposed of as product waste.
6 MEASURES IN CASE OF ACCIDENTS AND FIRES
6.1 After spillage: All chemical spillages must be dealt with as soon as possible to prevent contamination. Damage or staining
of the area affected (especially with liquid products). Attention is drawn to the Control of Pollution Act 1974, the provision
of which is enforced by local authorities. Sweep up spillages. Place in polyethene bags for disposal to an authorized waste
site. Wash the area with strong industrial detergent and hot water.
6.2 Extinguishing media suitable: compatible with all usual extinguishing media.
Not be used: N/A
6.3 First aid
Ingestion: Do not induce vomiting. Summon a doctor immediately.
Eye contact: Rinse immediately with opened eyelids under running water for 15 minutes and summon a doctor
immediately.
Skin contact: Remove contaminated clothing. Wash off immediately with soap and water. Consult a doctor if skin
irritation persists.
Inhalation: Remove to fresh air. Give oxygen if required. In the event of symptoms take medical treatment. 6.4 Further information: Sika Limited products are generally safe to use provided certain precautions normally taken when
handling chemicals are observed. Unless specified products should not come into contact with drinking water, foodstuffs or
food equipment and measures should be taken to prevent skin contact, since people with particularly sensitive skin may be
affected. The use of barrier creams, goggles and industrial gloves are recommended. The skin should be cleansed at the
end of each working period using a suitable industrial cleanser or warm water and soap, the use of solvents to clean the
skin is not recommended. Adequate ventilation of the working area is recommended. Take careful note of all safety
information on data sheets and labels.
7 INFORMATION ON TOXICITY
Contact with eyes, skin and mucous membranes may cause slight irritation. Sensitization and allergic reaction may occur.
8 INFORMATION ON ECOLOGICAL EFFECTS
Addition information
Do not allow to enter waste water drain, waterways or soil.
9 FURTHER INFORMATION
All statements are based on our experience to date. Form based on DIN 52900.
The information contained in this Safety Data Sheet corresponds to our level of knowledge at the time of publication. All warranties are excluded. Our most current General Sales Conditions shall apply. Please consult the Technical Data Sheet prior to
any use and processing.
01/2007 SAFETY DATA SHEET Sika Ltd., China No.96,JunDa Road, Eastern Section, GET Guangzhou, China, post code: 510530 Sikadur 42HE, Part A Tel: +86 20 82266066 Fax: +86 20 82266022 Pages: 2/2
The information in this safety data sheet respects the actual status of knowledge at the date of publication. They do not imply any
warranty. For warranty obligations the specific product descriptions and General Status Conditions are of relativance only.
N/A = not applicable blank = no data available
本文档为【西卡214金属灌浆料说明】,请使用软件OFFICE或WPS软件打开。作品中的文字与图均可以修改和编辑,
图片更改请在作品中右键图片并更换,文字修改请直接点击文字进行修改,也可以新增和删除文档中的内容。
该文档来自用户分享,如有侵权行为请发邮件ishare@vip.sina.com联系网站客服,我们会及时删除。
[版权声明] 本站所有资料为用户分享产生,若发现您的权利被侵害,请联系客服邮件isharekefu@iask.cn,我们尽快处理。
本作品所展示的图片、画像、字体、音乐的版权可能需版权方额外授权,请谨慎使用。
网站提供的党政主题相关内容(国旗、国徽、党徽..)目的在于配合国家政策宣传,仅限个人学习分享使用,禁止用于任何广告和商用目的。