物理实验:示波器的使用
物 理 实 验 报 告
姓名: 班级: 组别: 成绩:
合作者: 指导教师: 实验日期:
实验题目:示波器的使用
实验目的:
1( 从物理学角度了解示波器的结构和工作原理,为正确使用示波器打下理论基础。
2( 掌握SS—5702A型双踪示波器正确使用
方法
快递客服问题件处理详细方法山木方法pdf计算方法pdf华与华方法下载八字理论方法下载
。
实验仪器:
名 称 编 号 型 号
实验原理:
示波器是直接观察和测量电压信号的通用仪器。
示波管的电子枪发出高速电子束,射到荧光屏上产生一个光点。水平偏转板加上锯齿波扫描电压U,垂直偏转板加上待测电压U,荧光屏上的光点就扫描出一条t—U曲线。 XYY
示波器显示稳定波形的条件是
T=nT或f=nf,n=1,2,„ (1) XYyX
但U、U不是相干波源,二者频率的随机漂移导致(1)式不能持续成立。为此要用同步信XY
号强迫U随时与U同步,或用触发信号启动U振荡器工作,以便令每次的扫迹都能重合,实XYX
现稳定示波。
示波器的量程从几毫伏到几百伏,因此探头输入的U信号需经放大器、衰减器处理,才能Y
在屏上显示适当高度的波形。
在屏上测量波形峰值时,需将Y向偏转因数微调旋钮VARIABLE调到校正位置 (CAL),即顺时针旋到“喀嗒”声出现。计算波形峰值要注意
波形的电压值=VOLTS/DIV×探头倍数?POSITION倍数×纵向偏转格数 (2)
利萨如图形在Y方向有m个极值点,X方向有n个极值点,则U、U的频率具有以下关系: YX
to prevent the accumulation of air, both ends of the tube are required the Center to bake. 6.2.5 sets should be at the bottom 200mm lashing cable head is fixed rung, with a similar cable color of plastic lashings. Cable head using "equal-width stacked" layout, or according to the size and space within the enclosure cable volume adjust, but you must ensure uniform, neat and elegant. 6.2.6 disc cabinet within cable shield layer requirements
(3) ffnm::,YXXY
实验步骤:
详见实验讲义
实验内容:
1( 利用SS—5702A型双踪示波器观测GFG—8216A型函数信号发生器输出的不同信号波形。
2( 利用SS—5702A型双踪示波器观察两个相近频率正弦波的拍频现象。
3( 由GFG—8216A型函数信号发生器输出可调的已知频率,利用SS—5702A型双踪示波器形
成的利萨如图形,测量未知信号的频率
1000Hz正弦波各项测试参数记录:
UUVOLTS/DIV Y向格数 SEC/DIV X向一周期格数 周期T PP,P
f,1
quirementsenclosure cable volume adjust, but you must ensure uniform, neat and elegant. 6.2.6 disc cabinet within cable shield layer re width stacked" layout, or according to the size and space within the-milar cable color of plastic lashings. Cable head using "equalhe tube are required the Center to bake. 6.2.5 sets should be at the bottom 200mm lashing cable head is fixed rung, with a sito prevent the accumulation of air, both ends of t2
f: f 1:1 2:1 3:2 2 1结果
f 1
f 2= f2
波形
草图
to prevent the accumulation of air, both ends of the tube are required the Center to bake. 6.2.5 sets should be at the bottom 23—1—3 00mm lashing cable head is fixed rung, with a similar cable color of plastic lashings. Cable head using "equal-width stacked" layout, or according to the size and space within the enclosure cable volume adjust, but you must ensure uniform, neat and elegant. 6.2.6 disc cabinet within cable shield layer requirements